Breaching-technologies Pry Breaching Door Manuel d'utilisateur télécharger pdf (Page 7)

Pry Door. Your new breaching door has been engineered to simulate many scenarios for

forced entry training. As previously discussed, 2 different door construction types can be

simulated utilizing the 2 different types of engineered pins. Additionally, 1 to 3 lock sets

can be simulated utilizing the pin sockets located on the backside of the breaching door.

When used in conjunction with the 3 types of breaching pins, a total of 6 breaching

scenarios can be simulated as defined below:

Lock Set

Scenario 1 2 3

1 wood

2 wood wood

3 wood wood wood

4 metal

5 metal metal

6 metal metal metal

After closing the door, the desired type and quantity of BTI pins are inserted into the

sockets as shown below. The pin should insert a distance of approximately ¼” into the

socket when fully seated. Due to stresses and strains imparted upon the door structure

during breaching, slight misalignments will occur over time. Accordingly, the system

has been designed such that the amount of engagement into the socket is not extremely

critical.

Once the door has been breached, the broken pins may not fall out or may partially fall

out. A screw driver, or similar tool may be used (as shown) to remove the spent pins from

the opposite direction of installation if access is available.

1 2 3 4 5 6 7 8 9 10

Pas de commentaire

Breaching-technologies Pry Breaching Door Manuel d'utilisateur Page 7